Home › Blog › How to Sublimate a Hat

How to Sublimate a Hat

Custom caps are popular for teams, events and small brands, and sublimation gives them a full-color print you can't feel. The curved front is the tricky part. With the right blank, the right size and something to support the curve, it's straightforward.

By the CraftSizer team · Updated 2026-11-18

How to sublimate a hat in 5 steps: polyester front or a patch, design 2.5 to 4 inches wide and up to 2.25 inches tall, lint roll and pre-press, press at 385 to 400 degrees for 45 to 55 seconds, peel straight away
The five steps of hat sublimation.

Choosing a blank

Design size

Most cap front designs are 2.5–4 inches wide and no more than about 2.25 inches tall, so they sit on the flat-ish part of the front panel above the brim. Larger designs run into the seams and curves and come out faded at the edges. The design size calculator has a "cap front" option for your design's shape.

Settings

BlankTemperatureTimePressure
Polyester hat / cap front panel385–400 °F (196–204 °C)45–55 secMedium
Faux leather patch350–385 °F (177–196 °C)40–60 secLight–medium

Common starting points. Your blank's instructions come first. Full chart: sublimation time and temperature chart.

Step by step

  1. Print the design mirrored at about 300 DPI (check with the DPI checker), and trim close to the design.
  2. Prep the cap: lint roll the front and pre-press for a few seconds to remove moisture.
  3. Support the curve. With a hat press, use the curved platen. With a flat heat press, put a small pressing pillow or a rolled towel inside the cap so the front panel is pushed flat against the plate.
  4. Tape the print face down, centered above the brim, so it can't shift.
  5. Press at your settings, with butcher paper on top.
  6. Peel the paper straight up right away.

Common hat problems

ProblemLikely causeTry
Faded edgesDesign too big for the flat area, or uneven pressureSize down; support the curve with a pillow
Blurry or doubled printPaper moved on the curveTape all sides; lift straight up
Press mark on the brimThe plate edge pressed the brimLet the brim hang off the edge of the platen
Pale colorsNot enough polyester, or too little timeCheck the blank; add 5–10 seconds

Frequently asked questions

What size should a hat design be?

Most cap front designs are 2.5 to 4 inches wide and no more than about 2.25 inches tall, so they stay on the flat part of the front panel.

What temperature do you sublimate a hat?

A common starting point for a polyester cap front is 385 to 400 °F for 45 to 55 seconds with medium pressure. Follow your blank's instructions first.

Can you sublimate a hat with a regular heat press?

Yes. Put a small pressing pillow or rolled towel inside the cap to push the front panel flat, and let the brim hang off the edge of the plate.

Can you sublimate on a cotton or dark hat?

Not directly. Sublimate a polyester or faux leather patch and attach it, or use sublimation HTV or DTF.

Free tools for this

Free tool

Sublimation Time & Temperature Chart

Starting heat, time and pressure for shirts, mugs, tumblers and more, with a built-in press timer.

Free tool

HTV Shirt Design Size Calculator

What size to cut your iron-on design for adult, youth, toddler and baby shirts, and where to place it.

Free tool

Sublimation DPI & Print Size Calculator

Convert pixels to inches, find the pixels you need, and check if an image is sharp enough to print.

More articles